Creating a CLIO Interactive

Installing CLIO

The first step to creating an interactive is completing the CLIO Installation guide. After you're done, you've successfully created your first Interactive!

Now, we can look at the default settings to setup this Interactive how we want.

Configuring an Interactive

There is a @Configuration.json file stored in the 'config' folder located within the CLIO root directory. This file provides a place for Interactive-specific settings to be saved persistently. When these settings are changed through Facilitator Mode, this file is updated to reflect these changes.

Screensaver Options

Setting	Description	Expected Parameters
Text	This is the text that is displayed when the screensaver is activated.	Plain Text
Image	This is the image that is displayed when the screensaver is activated.	Image File

Device Options

Setting	Description	Expected Parameters
Screen Brightness	This is the default brightness when used on the POP kiosk.	1 - 10
PIN Code	PIN to allow facilitators to return the kiosk from Exhibit Mode to Facilitator Mode.	Any four-digit number.

Settings

Setting	Description	Expected Parameters
Default Program	This is the default brightness when used on the POP kiosk.	1 - 10
Screensaver	Enable or disable the screensaver.	"true" or "false"
Contrast Mode	Configure whether a contrast mode is enabled by default.	"blackonwhite", "whiteonblack", or "greenonblack"
Activity Timeout	The amount of time the kiosk should remain idle while in Exhibit Mode before returning to the activity carousel.	"15", "30", "60", "300", "600", or "99999999"
Slide Duration	The amount of time each activity should be displayed on the carousel while in Exhibit Mode.	"5000", "10000", "15000", "30000", "60000", "120000", or "300000"