Printing the POP Kiosk Case

Process

This section could use more detail. You can help by expanding it.

Parts

Case

Main Article: POP Kiosk Case (part)

This is the main case that protects the Raspberry Pi computer and touchscreen display.

Protection

Collar

Main Article: POP Kiosk Collar (part)

The collar protects the exposed edges of the Raspberry Pi touchscreen display, decreasing the chances that the kiosk screen will be damaged from minor bumps and falls.  It is printed in two parts and held together by M2 screws.

Bumper

Main Article: POP Kiosk Bumper (part)

The bumper also protects the exposed edges of display, but it is printed as one part with a soft and flexible TPU filament.  When printed with specific infill settings, it can provide additional protection to bumps and falls.  This bumper is used instead of the collar and was created for use in mobile pop-up exhibits.

Cover

Main Article: POP Kiosk Cover (part)

The cover provides protection to the front of the kiosk display by attaching directly to the collar or bumper.  This cover was created to provide protection to the glass screen during transport and storage.

Mount

Modular Case Adapter

Main Article: POP Kiosk Modular Case Adapter (part)

This adapter is attached to the back, top or bottom of the kiosk using two M5 bolts. It can be used with any accessories created for the popular Modular Mounting System. It is printed in two parts and attached together with an M5 bolt and optional glue. The mount can be used with a two- or three-prong adapter.

Arm

Main Article: POP Kiosk Arm (part)

There are 30mm, 60mm, 90mm 150mm and 240mm arm attachments for the Modular Mounting System.  These can be used to extend the length of the mount system, but caution should be used to verify that the kiosk is fully supported.  This includes axis changers and prong adapters.

Foot

Main Article: POP Kiosk Foot (part)

The foot is used to display the kiosk on a flat surface, such as a table or shelf.  It is printed in two parts then attached together with an M5 bolt and optional glue.  The foot can be used with a two- or three-prong adapter.  The foot can be used with suction cups to more securely attach to sheer surfaces, such as glass or polished stone.  Additionally, 3D printed TPU or third-party anti-slip grips can be attached to the bottom.

Thumbscrews

Main Article: POP Kiosk Thumbscrew (part)

The thumbscrews are used with standard M5 bolts to make it easier to tighten and loosen the display for repositioning.