Assembling the POP Kiosk Case

This section contains CLIO documentation.

Refining the Print

Removing Excess Supports

When creating objects with many forms of 3D printing, you will need to remove the excess material the print uses to create support structures. The POP kiosk case is the only print that requires extensive support structures and we recommend the Cura Slicer program's "Tree Supports" option for ease of removal.

These supports are made to be removed and the process is generally straight forward. Using a pair of side-cutting pliers, you can cut any support connections. Then, use needle-nose pliers to remove the support structures.

This section requires photographs, illustrations or screenshots.

Filling and Sanding the Parts

After the support structures are removed, there may be some marks left on the final part's surface. These can generally be removed by using sandpaper. Start with 120-grit sandpaper and progressively work your way up to 1500-grit sandpaper.

Working in a straight line with low-grit paper can quickly remove marks from the printed surface, while sanding in tight circles with higher-grit paper can help minimize the appearance of surface anomalies. During this sanding process, you can use a spot putty to fill large gouges or soften layer lines. When using 1000-grit or higher sandpaper, you can incorporate water into the process to increase the surface polish.

Note

Note: Always be sure to follow the proper safety precautions.

Sanding 3D printed parts creates a fine dust of harmful microplastic particulates. You should always wear protective goggles, a mask, gloves and wash your clothes after sanding is finished. Always ensure you have adequate ventilation.

Resource: How To Sand Your 3D Prints – Makerbot

Painting the Parts

Before you can use spray paint on a finished print, it is generally recommended to use a primer. Some spraypaint includes a primer for a one-step painting process. Use wide strokes that pass over the part being painted, but do not start or stop on it. Always try to hold the spraypaint can nozzle 10" - 12" from the object. Use multiple thin layers to improve evenness and decrease paint running.

Note

Note: Always be sure to follow the proper safety precautions.

You should always wear protective goggles, a mask, and gloves while using spray paint and primer. Always ensure you have adequate ventilation.

Resource: How To Paint Your 3D Prints – Makerbot